D-Link DAP-1665

49D-Link DAP-1665 User Manual
Section 3 - Conguration
LAN Setup
The LAN Setup page enables you to congure the Local Area Network (LAN) settings for the access point. From this page you
can adjust your local network’s IP address settings. If you are connecting the access point to a network which is using IPv6, the
DAP-1665 can be congured to operate using the IPv6 protocol.
Dynamic/Static IP
Device Name:
My LAN
Connection is:
IP Address:
Subnet Mask:
Gateway
Address:
Primary DNS
Server:
Secondary DNS
Server:
You can change the name of your access point to make it easier
to identify. Enter a name for the access point in the Device Name
eld. You can use this name in your web browser address eld
to access the web-based conguration utility.
Example: http://devicename
Select how you would like to congure the access point’s IP
address settings from the drop-down menu:
Dynamic IP(DHCP) - The access point will request an IP address
from the DHCP server that it is connected to. The IP Address,
Subnet Mask, etc. will automatically be assigned.
Static IP - You can manually specify the IP address settings for
the access point.
Enter the IP Address for the access point (for Static IP only).
Enter the Subnet Mask to be used by the access point (for
Static IP only).
Enter the default Gateway Address to be used by the access
point (for Static IP only).
Enter the Primary DNS Server address to be used by the access
point (for Static IP only).
Enter the Secondary DNS Server address to be used by the
access point (for Static IP only).
Click Save Settings at the top of the page to save the current
conguration.