D-Link DAP-1665

34D-Link DAP-1665 User Manual
Section 3 - Conguration
Access Point Mode
Wireless Mode:
Enable Wireless:
Wireless
Network Name:
802.11 Mode:
Wireless
Channel:
Enable Auto
Channel Scan:
Channel
Width:
Select Access Point from the drop-down menu.
Check the box to Enable the wireless function for the 2.4GHz
band. You may uncheck the box to disable all wireless functions.
If wireless is enabled, you may also set up a specic schedule.
Select a schedule from the drop-down menu or click Add New
to create a new schedule. The schedule is set to Always by
default.
Specify a Network Name (SSID) to identify the 2.4GHz network.
This is the network name that wireless clients will search for
when connecting to your wireless network.
Select one of the following:
802.11n Only - Select if you are only using 802.11n wireless
clients.
Mixed 802.11n and 802.11g - Select if you are using a mix of
802.11n and 802.11g wireless clients.
Mixed 802.11n, 802.11g and 802.11b - Select if you are using
a mix of 802.11n, 802.11g, and 802.11b wireless clients.
Indicates the channel setting for the DAP-1665. The Channel
can be changed to the channel setting for an existing wireless
network or to reduce interference in congested areas. If Auto
Channel Scan is enabled, this option will not be available.
Check the box to Enable Auto Channel Scan. This will allow
the DAP-1665 to automatically choose the channel with the
least amount of interference.
Select the Channel Width:
Auto 20/40 MHz - Select if you are using both 802.11n and
non-802.11n wireless devices.
20 MHz - Select if you are not using any 802.11n wireless clients.
2.4GHz Band