19D-Link DAP-1665 User Manual
Section 2 - Installation
WPS Button
Press the WPS button on your existing wireless router or AP.
Note: Usually the WPS LED on your router will start to blink. If necessary, check your router’s user manual for more information.
2
3
Within one minute, press and hold the WPS button on the side of the DAP-1665 for a minimum of one second. The WPS LED will blink. When the
Security LED becomes a solid green, it means wireless security is enabled. Allow up to two minutes for the WPS process to complete.
Note: For optimal performance using Repeater Mode, place your DAP-1665 in between your router and your dead zone, making sure it’s placed in a location where
the signal is still strong.
RESET
LAN
5V
1A
To Next Page
Loading...
