DAP-600P Wireless AC2600 Wave 2 MU-MIMO Dual Band
PoE Access Point / Router
User Manual
Configuring via Web-based Interface
Parameter Description
Network name (SSID)
A name of the Mesh network. This value should be the same for all
devices of your Mesh network.
Clients connected to devices of a Mesh network cannot see the Mesh
network and cannot connect to it.
In the Security Settings section, specify security settings of your Mesh network.
5
To do this,
select the needed type of authentication
6
from the Network authentication drop-down list.
When the WPA2-PSK authentication type is selected, the following fields are displayed:
Parameter Description
Password PSK
A password for WPA encryption. Click the Show icon ( ) to
display the entered key. By default, WPS PIN from the barcode label
is used as the network key.
Encryption type An encryption method: AES.
When you have configured the parameters, click the APPLY button.
To complete your Mesh network configuration, connect the subordinate device to a LAN port of the
main device using an Ethernet cable. Wait for about 5-6 minutes. When all the settings are applied,
the POWER/WLAN LED should be solid blue. Then, if needed, disconnect the Ethernet cable and
move the subordinate device to its workplace.
To view data on the current state of your Mesh network, select the needed value from the
Statistics drop-down list.
• Network Overview: When this value is selected, information on all devices of your Mesh
network is displayed on the page. The value is unavailable if your device is configured as a
subordinate one.
• List of APs: When this value is selected, information on all devices of your Mesh network
is displayed on the page.
• List of Clients: When this value is selected, information on all clients connected to the
devices of your Mesh network is displayed on the page.
• Neighbours: When this value is selected, a connection scheme of your Mesh network
devices is displayed on the page.
Parameter Description
Network Overview / List of APs
Model
The model of a device.
5 Security settings should be the same for all devices of your Mesh network.
6 The full list will be available in the next firmware version.
Page 146 of 235
To Next Page
Loading...
