D-Link DCS-1130

9D-Link DCS-1130 User Manual
Section 2 - Installation
Connect the Ethernet Cable
Connecting to a router
Connecting to a broadband modem
Connect one end of the blue Ethernet cable included in your package to the Ethernet port on the back of the
DCS-1130 camera. Connect the other end of the cable to an available LAN port on your router or broadband
modem.
Attach the power adapter to the power jack located on the back of the DCS-1130 and
connect the power adapter to a power outlet. After connecting the power adapter, you
should see the status LED on the front of the camera turn on.
The status LED will light red when it receives power, will light green after the camera
connectstothenetwork,andwillashgreenwhenthecameraisbeingaccessed.
Connect the Power Adapter