D-Link DCS-1130 - Setup > Audio and Video

20D-Link DCS-1130 User Manual
Section 3 - Configuration
Setup > Audio and Video
Encode Type: This sets the video codec used for the video stream. You
canchooseMPEG-4orMJPEG(JPEG).InternetExplorerbrowserscan
viewbothMPEG-4andMJPEGvideostreams,andnon-IEbrowserscan
onlyviewMJPEGvideostreams.
Resolution: This sets the display resolution of the video stream. If the
Resolution is different than the Sensor Output size, the video will be
shrunkenorenlargedtotheResolutionsizeyousethere.
FPS: This sets the target number of frames per second (FPS) for the
video stream. Higher frame rates will provide smoother video.
bps: This sets the target bitrate of the video stream. Higher bitrates will
providebetterqualityvideo.WhentheEncodeTypeissettoMJPEG,you
cannot change the bps setting. Also, available bps settings may change
dependingonwhattheEncodeType,SensorOutput,Resolution,and
FPS settings are set to.
JPEG Quality:ThissetstheJPEGqualityofanymanualsnapshotsyoutakewhenthisvideoproleisselected
RTSP URL:Thissettingallowsyoutosetasufxforyourcamera’sRTSPURLsoyoucanviewyourcamera’svideo
withthisvideoprole’ssettings.Forexample,ifyouenter“mpeg4”asyourRTSPURLsettingandyourcamera’sIP
is192.160.0.20,youcanviewyourcamera’svideowiththesesettingsthrough192.160.0.20/mpeg4.
Youmaycongurefourvideoproleswithdifferentsettingsforyourcamera.Youmayalsosetupdifferentprolesfor
yourcomputerandmobiledisplay.Inaddition,youmayconguretheaudio(speakersandmicrophone)settingsfor
your camera.