D-Link DCS-1130 User Manual

25D-Link DCS-1130 User Manual
Section 3 - Configuration
Recording Options
Resolution:Thiswillletyousetwhichvideoproleyouwishtouseto
recordvideo.Pleasenotethatifthebitrate(bps)ofthevideoproleis
higher than your Samba network drive’s throughput, the recording’s
framerate (FPS) may be reduced.
Record until: You can use this setting to adjust how much free space
must remain when recording. It is suggested that you set this to at least
32M to allow for enough buffer space for the camera to record with.
When storage is full: When your storage device is full or has reached
thefree spacelimit speciedin Record until,you canchoose to stop
recording, or you can have the camera delete old recordings to free space
for new recordings to be saved.
Event Based: Event based recording will allow you to record video when
speciceventshappen.
Motion detection triggered recording: Enabling this option will set the
camera to record video when motion is detected by the camera.
Prerecord: This will set how many seconds of video before the event
takes place will be recorded.
Postrecord: This will set how many seconds of video after the event
takes place will be recorded.
Example:UsingmotiondetectiontriggeredrecordingandsettingPrerecordto5secondsandPostrecordto9seconds,
thecamerawillsavevideofrom5secondsbeforemotionwasdetectedto9secondsaftermotionwasdetected.
Continuous: This will set the camera to record continuously.
Scheduled Recording:Thiswillsetthecameratoautomaticallyrecordvideoduringthespeciedtimesinthetable
below.
After making any changes, click the Save Settings button to save your changes, or click the Don’t Save Settings
button to discard your changes.

D-Link DCS-1130 Specifications

General

Brand	D-Link
Model	DCS-1130
Category	Security Camera
Language	English