EasyManuals Logo

D-Link DCS-5300 User Manual

D-Link DCS-5300
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #52 background imageLoading...
Page #52 background image
51D-Link DCS-5300 User Manual
There are 4 conditions related to the digital input and three windows for motion detection. There can be multiple selections.
Select the appropriate digital input condition according to the characteristics of the external device. “High”, “low” indicate
external voltage input for level trigger, while “rising”, “falling” is for edge triggers. There are three windows shown for the
names you dened for motion detection. “Undened” will show instead of the window title if motion detection is not setup
yet. An active, named motion window must be checked for motion detection to be possible.
Check and save this option to reset the external device at the digital output back to the original state.
There are four options for two actions regarding either trigger condition. They can have multiple selections. While
choosing the trigger output alarm, the digital output will short both pins to connect the circuit of the attached external
device; otherwise both pins will be open. While choosing to upload snapshots, the method can be either email or FTP.
The snapshot names will be “videopre.jpg”, videotrg.jpg”, and “videopos.jpg” respectively for the snapshots before event,
right upon event, and after event. The date and time sufx may be added according to the option. Conrm the external
mail or FTP server settings in network conguration.
Trigger condition:
Reset output:
Trigger action:
Sequential Operation
The DCS-5300 will send snapshots at the specied interval to the external server according to the chosen method.
Remember this operation is dependent to the weekly schedule.
Any upload action specied in the options above will use the method chosen here. The captured snapshot named “video.
jpg” will be attached in the email with subject “Periodic snapshots.”
The captured snapshots will upload to the external FTP server with the le name depending on the next option. It can be
used to refresh the captured image stored in the external web server to build creative homepages.
Snapshot every
second(s):
Send snapshots
by email:
Send snapshots
by FTP:

Other manuals for D-Link DCS-5300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the D-Link DCS-5300 and is the answer not in the manual?

D-Link DCS-5300 Specifications

General IconGeneral
Digital zoom4 x
Maximum frame rate30 fps
Camera shutter speed1/60 - 1/15000 s
Minimum illumination1 lx
Maximum video resolution320 x 240 pixels
Pan range270 °
Sensor typeCCD
Product colorSilver
Tilt angle range-90 - 90 °
Built-in microphoneYes
Optical sensor size1/4 \
Focus2.0
I/O portsA/V MIC
Power supply type12VDC 1.5A
Cabling technology10BaseT, 100BaseT
Supported network protocolsTCP/IP, HTTP, SMTP, FTP, Telnet, NTP, DNS, DHCP
Compatible operating systemsMicrosoft Windows XP, 2000, Me, 98SE
Dimensions (W x D x H) (imperial)4.1 x 4 x 4.4 \
Minimum system requirementsInternet Explorer 5.x +

Related product manuals