53D-Link DCS-5300 User Manual
Click on the Default button to access the factory setting restoration and
camera calibration options from the Tools menu.
Click Apply on the screen to restore factory default settings. This means any changes made will be lost and the system
will be reset to the initial status when shipped from the factory. After conrmation, the system will restart and require
the Installation Wizard software program to locate the IP address of the DCS-5300.
Click Apply under Calibrate to restore them camera’s factory lens position. This means that the camera will be
recalibrated to the default center to position to recover from any external forces that may have affected it.
Configuration > Tools > Default
Click Default
To Next Page
Loading...
