68D-Link DCS-5300 User Manual
Next, click the Applications button under the Tools tab to set the application settings for the DCS-5300.
In this window, follow the steps below to set the application settings for snapshots
to be sent to your email account or FTP server when triggered by a motion sensor
or other external device:
• Select the weekdays you would like to record and enter the “Snapshots begin” time and “Snapshots end” time for
the weekly schedule, or select All the time except for the above schedule if you want to enable full time snapshot
recording.
• Check Event operation.
• Set the delay “before detecting next event” to avoid continuous false alarms following the original event.
• Set the delay to “take snapshots after event” to capture the direction of the moving object.
• Check the trigger condition for input and motion detection (in this case “Input is Low”).
• Check Trigger output alarm while input condition matched and Upload snapshots while motion detected.
• Select to either send snapshots by email or by FTP.
Click the Apply button when nished. You are now able to send snapshots, based on triggered recording, to your
email account or FTP server.
x
x
x
Click Application
To Next Page
Loading...
