D-Link DES-3326S - Page 100

D-Link DES-3326S Layer 3 Switch CLI Reference
config stp
Purpose
Used to setup STP and RSTP on the Switch.
Syntax
config stp {maxage <value>|hellotime <value>|forwarddelay
<value>|priority <value>|fbpdu [enable|disable]| txholdcount <1-10>|
version[rstp|stp]}
Description
This command is used to setup the Spanning Tree Protocol for the entire
Switch. By default, the Switch is uses Rapid Spanning Tree Protocl (RSTP)
when it is enabled. The default settings for the Switch have Spanning Tree
Protocol disabled (see enable/disable stp commands).
Parameters
maxage <value> − The maximum amount of time (in seconds) that the Switch
will wait to receive a BPDU packet before reconfiguring STP. The default is 20
seconds.
hellotime <value> − The time interval between transmission of configuration
messages by the root device. The default is 2 seconds.
forwarddelay <value> − The maximum amount of time (in seconds) that the
root device will wait before changing states. The default is 15 seconds.
priority <value> − A numerical value between 0 and 61440 that is used in
determining the root device, root port, and designated port. The device with
the highest priority becomes the root device. The lower the numerical value,
the higher the priority. The default is 32,768.
fbpdu [enable|disable] − Allows the forwarding of STP BPDU packets from
other network devices when STP is disabled on the Switch. The default is
enabled.
txholdcount <1-10> - the maximum number of Hello packets transmitted per
interval. Default value = 3.
version [rstp|stp] - select the Spanning Tree Protocol version used for the
Switch. For IEEE 802.1d STP select stp. Select rstp for IEEE 802.1w Rapid
STP.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure STP with maxage 18 and hellotime 4:
DES-3326S:4#config stp maxage 18 hellotime 4
Command: config stp maxage 18 hellotime 4
Success.
DES-3326S:4#
94