D-Link DES-3326S - Time and SNTP Commands

D-Link DES-3326S Layer 3 Switch CLI Reference
24
TIME AND SNTP COMMANDS
The Simple Network Time Protocol (SNTP) (an adaptation of the Network Time Protocol (NPT)) commands in
the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
{primary <ipaddr> | secondary <ipaddr> | poll-interval
<int 30-99999>
}(
1
)
enable snt
p
disable snt
p
confi
g
time <date ddmmm
yyyy
> <time hh:mm:ss >
config time-zone
{operator(1) [+ | -] | hour(2) <gmt_hour 0-13> | min(3)
<minute 0-59>
}
config dst
[disable|repeating {s-week<start_week 1-4,last>
| s-wday <start_weekday sun-sat>
| s-mth <start_mth 1-12>
| s-time <start_time hh:mm>
| e-week <end_week 1-4,last>
| e-wday <end_weekday sun-sat>
| e-mth <end_mth 1-12>
| e-time <end_time hh:mm>
| offset [30 | 60|90|120]}
| annual {s-date <start_date 1-31>
| s-mth <start_mth 1-12>
| s-time <start_time hh:mm>
| e-date <end_date 1-31>
| e-mth <end_mth 1-12>
| e-time <end_time hh:mm>
|
offset
[
30
|
60
|
90
|
120
]}]}
show time
config sntp
show snt
p
Each command is listed, in detail, in the following sections.
205