D-Link DES-3326S - DVMRP Commands

D-Link DES-3326S Layer 3 Switch CLI Reference
32
DVMRP COMMANDS
The DVMRP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters)
in the following table.
Command Parameters
config dvmrp ipif <ipif_name 12>
all
metric <value 1-31>
probe <sec 1-65535>
neighbor_timeout <sec 1-65535>
state [enable|disable]
enable dvmrp
disable dvmrp
show dvmrp
neighbor
ipif <ipif_name 12>
ipaddress <network_address>
show dvmrp
nexthop
ipif <ipif_name 12>
ipaddress <network_address>
show dvmrp
routing_table
ipaddress <network_address>
show dvmrp ipif <ipif_name>
Each command is listed, in detail, in the following sections.
255