D-Link DES-3326S - OSPF Configuration Commands

D-Link DES-3326S Layer 3 Switch CLI Reference
36
OSPF CONFIGURATION COMMANDS
The OSPF configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
router_id <ipaddr>
enable ospf
disable ospf
show ospf
create ospf area <area_id>
type [normal|stub]
stub_summary [enable|disable]
metric <value 0-65535>
delete ospf area <area_id>
config ospf area <area_id>
type [normal|stub]
stub_summary [enable|disable]
metric <value 1-65535>
show ospf area <area_id>
create ospf host_route <ipaddr>
area <area_id>
metric <value>
delete ospf host_route <ipaddr>
config ospf host_route <ipaddr>
area <area_id>
metric <value>
show ospf host_route <ipaddr>
create ospf aggregation <area_id>
<network_address>
lsdb_type [summary]
advertise [enable|disable]
delete ospf aggregation <area_id>
<network_address>
lsdb_type [summary]
config ospf aggregation <area_id>
<network_address>
lsdb_type [summary]
advertise [enable|disable]
show ospf aggregation <area_id>
show ospf lsdb area <area_id>
advertise_router <ipaddr>
type
[
rtrlink
|
netlink
|
summar
y|
assummar
y|
asextl
config ospf
276