D-Link DES-3326S - Network Monitoring Commands

D-Link DES-3326S Layer 3 Switch CLI Reference
10
NETWORK MONITORING COMMANDS
The network monitoring commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
show packet ports <portlist>
show error ports <portlist>
show utilitzation
clear counters ports <portlist>
clear log
show log index <value>
enable syslog
disable syslog
show syslog
create syslog host all
<index 1-4>
severity
informational
warning
all
facility
local0
local1
local2
local3
local4
local5
local6
local7
udp_port <int>
ipaddress <ipaddr>
state [enable|disable]
config syslog host all
<index 1-4>
severity
informational
warning
all
facility
local0
local1
local2
local3
local4
74