D-Link DES-3326S - Stacking Commands

D-Link DES-3326S Layer 3 Switch CLI Reference
23
STACKING COMMANDS
The stacking configuration commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command Parameters
config stacking mode disable
enable
slave
master
auto
show stacking {mode}
Each command is listed, in detail, in the following sections.
NOTE: Switch stacking requires that a stacking module be installed on
every Switch used for the stacked group. If a stacking module is detected,
the default settings for the Switch allow it to function as either a member of
a stacked group or as a standalone device.
201