D-Link DES-3326S - Page 206

D-Link DES-3326S Layer 3 Switch CLI Reference
show traffic_segmentation
Purpose Used to display the current traffic segmentation configuration on the Switch.
config traffic_segmentation <portlist> forward_list [null|<portlist>]
The show traffic_segmentation command is used to display the current
traffic segmentation configuration on the Switch.
Parameters
<portlist> − Specifies a range of ports for which the current traffic
segmentation configuration on the Switch will be displayed. The port list is
specified by listing the beginning port number and the highest port number of
the range. The beginning and end of the port list range are separated by a
dash. For example, 3 specifies port 3. 4 specifies port 4. 3-4 specifies all of the
ports between port 3 and port 4 − in numerical order.
Restrictions The port lists for segmentation and the forward list must be on the same
Switch.
Syntax
Description
Example usage:
To display the current traffic segmentation configuration on the Switch.
DES-3326S:4#show traffic_segmentation
Command: show traffic_segmentation
Traffic Segmentation Table
Port Forward Portlist
---- --------------------------------------------------
1 9-15
4 9-15
7 9-15
16 1-26
2 9-15
3 9-15
5 9-15
6 9-15
8 9-15
9 9-15
10 9-15
11 1-26
12 1-26
13 1-26
14 1-26
15 1-26
17 1-26
18 1-26
19 1-26
20 1-26
21 1-26
22 1-26
23 1-26
24 1-26
25 1-26
26 1-26
DES-3326S:4#
200