D-Link DES-3326S - Spanning Tree

D-Link DES-3326S Layer 3 Switch CLI Reference
33
PIM COMMANDS
The PIM commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in
the following table.
Command Parameters
config pim [ipif <ipif_name 12>| all ] { hello <sec 1-18724>
| jp_interval <sec 1-18724> | state [ enable |
disable ]}
enable pim
disable pim
show pim neighbor {ipif <ipif_name 12> | ipaddress
<network_address>}
show pim {ipif <ipif_name 12>}
Each command is listed, in detail, in the following sections.
262