D-Link DES-3326S - Spanning Tree Commands

D-Link DES-3326S Layer 3 Switch CLI Reference
11
SPANNING TREE COMMANDS
The Switch supports 802.1w Rapid STP and 802.1d STP. The spanning tree commands in the Command Line
Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
config stp maxage <value>
hellotime <value>
forwarddelay <value>
priority <value>
fdpdu [enable|disable]
txholdcount <1-10>
version [rstp|stp]
config stp ports <portlist>
cost <value>
priority <value>
migrate [yes|no]
edge [true|false]
p2p [true|false|auto]
state [enable|disable]
enable stp
disable stp
show stp
show stp ports <portlist>
Each command is listed, in detail, in the following sections.
93