D-Link DES-3326S - Page 98

D-Link DES-3326S Layer 3 Switch CLI Reference
show syslog host
Purpose Used to display the syslog hosts currently
configured on the Switch.
Syntax show syslog host {<index 1-4>}
Description
The show syslog host command is used to
display the syslog hosts that are currently
configured on the Switch.
Parameters
<index 1-4> − Specifies that the command will
be applied to an index of hosts. There are four
available indexes, numbered 1 through 4.
Restrictions None.
Example Usage:
To show Syslog host information:
DES-3326S:4#show syslog host
Command: show syslog host
Syslog Global State: Disabled
Host Id Host IP Address Severiry Facility UDP port Status
------- --------------- -------------- -------- -------- --------
1 10.1.1.2 All Local0 514 Disabled
2 10.40.2.3 All Local0 514 Disabled
3 10.21.13.1 All Local0 514 Disabled
Total Entries : 3
DES-3326S:4#
92