D-Link DES-3326S - Page 260

D-Link DES-3326S Layer 3 Switch CLI Reference
show rip
Purpose
Used to display the RIP configuration and
statistics for the Switch.
Syntax
show rip {ipif <ipif_name>}
Description
This command will display the RIP configuration
and statistics for a given IP interface or for all IP
interfaces.
Parameters
<ipif_name> − the name of the IP interface for
which you want to display the RIP configuration
and settings. If this parameter is not specified,
the show rip command will display the global
RIP configuration for the Switch.
Restrictions
None.
Example Usage:
To display RIP configuration.
DES-3326S:4#show rip
Command: show rip
RIP Interface Settings
RIP Global State : Disabled
Interface IP Address TX Mode RX Mode Authen- State
tication
------------- ------------------ ---------- ------------- ---------- -----
System 10.41.44.33|8 Disabled Disabled Disabled Disabled
Total Entries : 1
254