D-Link DES-3326S - Page 262

D-Link DES-3326S Layer 3 Switch CLI Reference
config dvmrp
Purpose
Used to configure DVMRP on the Switch.
Syntax
config dvmrp [ipif <ipif_name>|all] {metric
<value>|probe <second>|neighbor_timeout
<second>|state [enable|disable]
Description
This command is used to configure DVMRP on
the Switch.
Parameters
<ipif_name> − The name of the IP interface for
which DVMRP is to be configured.
all − Specifies that DVMRP is to be configured for
all IP interfaces on the Switch.
metric <value> − Allows the assignment of a
DVMRP route cost to the above IP interface. A
DVMRP route cost is a relative number that
represents the real cost of using this route in the
construction of a multicast delivery tree. It is
similar to, but not defined as, the hope count in
RIP. The default is 1.
probe <second> − DVMRP defined an extension
to IGMP that allows routers to query other routers
to determine if a multicast group is present on a
given router subnetwork or not. This is referred
to as a ‘probe’. The default value is 10 seconds.
neighbor_timeout <second> − The time period
for which DVMRP will hold Neighbor Router
reports before issuing poison route messages.
The default value is 35 seconds.
state [enable|disable] − Allows DVMRP to be
enabled or disabled.
Only administrator-level users can issue this
command.
Restrictions
Example Usage:
To configure DVMRP configurations of IP interface System:
DES-3326S:4#config dvmrp ipif System neighbor_timeout 30 metric 1 probe 5
Command: config dvmrp ipif System neighbor_timeout 30 metric 1 probe 5
Success
DES-3326S:4#
256