D-Link DES-3326S - Page 122

D-Link DES-3326S Layer 3 Switch CLI Reference
show bandwidth_control
Purpose Used to display the bandwidth control
configuration on the Switch.
Syntax
show bandwidth_control {<portlist>}
Description
The show bandwidth_control command
displays the current bandwidth control
configuration on the Switch, on a port-by-port
basis.
Parameters
<portlist> − Specifies a range of ports to be
configured. The port list is specified by listing
the lowest Switch number and the beginning
port number on that Switch, separated by a
colon. Then the highest Switch number, and the
highest port number of the range (also
separated by a colon) are specified. The
beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies
Switch number 1, port 3. 2:4 specifies Switch
number 2, port 4. 1:3-2:4 specifies all of the
ports between Switch 1, port 3 and Switch 2,
port 4 − in numerical order.
Restrictions None.
Example usage:
To display bandwidth control settings:
DES-3326S:4#show bandwidth_control 1-10
Command: show bandwidth_control 1-10
Bandwidth Control Table
Port RX Rate (Mbit|sec) TX_RATE (Mbit|sec)
---- ------------------------ ----------------------
1 no_limit 10
2 no_limit 10
3 no_limit 10
4 no_limit 10
5 no_limit 10
6 no_limit 10
7 no_limit 10
8 no_limit 10
9 no_limit 10
10 no_limit 10
DES-3326S:4#
116