D-Link DES-3326S - Page 129

D-Link DES-3326S Layer 3 Switch CLI Reference
show 802.1 default_priority
Purpose Used to display the currently configured 802.1p
priority value that will be assigned to an
incoming, untagged packet before being
forwarded to its destination.
Syntax
show 802.1p default_priority {<portlist>}
Description
The show 802.1p default_priority command
displays the currently configured 802.1p priority
value that will be assigned to an incoming,
untagged packet before being forwarded to its
destination.
Parameters
<portlist> − Specifies a range of ports to be
configured. The port list is specified by listing
the lowest Switch number and the beginning
port number on that Switch, separated by a
colon. Then the highest Switch number, and the
highest port number of the range (also
separated by a colon) are specified. The
beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies
Switch number 1, port 3. 2:4 specifies Switch
number 2, port 4. 1:3-2:4 specifies all of the
ports between Switch 1, port 3 and Switch 2,
port 4 − in numerical order.
Restrictions None.
123