D-Link DES-3326S - Page 158

D-Link DES-3326S Layer 3 Switch CLI Reference
config igmp_snooping
Purpose Used to configure IGMP snooping on the
Switch.
Syntax
config igmp_snooping [<vlan_name 32>|all]
{host_timeout <sec>|router_timeout
<sec>|leave_timer <sec>|state
[enable|disable]}
Description This command allows you to configure IGMP
snooping on the Switch.
Parameters
<vlan_name 32> − The name of the VLAN for
which IGMP snooping is to be configured.
host_timeout <sec> − Specifies the maximum
amount of time a host can be a member of a
multicast group without the Switch receiving a
host membership report. The default is 260
seconds.
route_timeout <sec> − Specifies the maximum
amount of time a route can be a member of a
multicast group without the Switch receiving a
host membership report. The default is 260
seconds.
leave_timer <sec 0-16711450> − Leave timer.
The default is 2 seconds.
state [enable|disable] − Allows you to enable or
disable IGMP snooping for the specified VLAN.
Restrictions Only administrator-level users can issue this
command.
Example usage:
To configure the igmp snooping:
DES-3326S:4#config igmp_snooping default host_timeout 250
state enable
Command: config igmp_snooping default host_timeout 250 state
enable
Success.
DES-3326S:4#
152