D-Link DES-3326S - Page 173

D-Link DES-3326S Layer 3 Switch CLI Reference
config 802.1x auth_parameter
Purpose Used to configure the 802.1x Authentication parameters on a range of ports.
The default parameter will return all ports in the specified range to their default
802.1x settings.
Syntax
config 802.1x auth_parameter ports [<portlist>|all]
[default|{direction [both|in]|port_control [force_unauth|auto|force_auth]|
quiet_period <sec 0-65535>| tx_period <sec 1-65535>| supp_timeout
<sec 1-65535>| server_timeout <sec 1-65535>| max_req <value 1-
10>|reauth_period <sec 1-65535> |enable_reauth [enable|disable]}]
Description
The config 802.1x auth_parameter command is used to configure the 802.1x
Authentication parameters on a range of ports. The default parameter will
return all ports in the specified range to their default 802.1x settings.
Parameters
<portlist> − Specifies a range of ports. The port list is specified by listing the
lowest Switch number and the beginning port number on that Switch,
separated by a colon. Then the highest Switch number, and the highest port
number of the range (also separated by a colon) are specified. The beginning
and end of the port list range are separated by a dash. For example, 1:3
specifies Switch number 1, port 3. 2:4 specifies Switch number 2, port 4. 1:3-
2:4 specifies all of the ports between Switch 1, port 3 and Switch 2, port 4 − in
numerical order.
all − Specifies all of the ports on the Switch.
default − Returns all of the ports in the specified range to their 802.1x default
settings.
direction [both|in] − Determines whether a controlled port blocks
communication in both the receiving and transmitting directions, or just the
receiving direction.
port_control − Configures the administrative control over the authentication
process for the range of ports.
force_auth − Forces the Authenticator for the port to become authorized.
Network access is allowed.
auto − Allows the port’s status to reflect the outcome of the authentication
process.
force_unauth − Forces the Authenticator for the port to become unauthorized.
Network access will be blocked.
quiet_period <sec 0-65535> − Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535> - Configures the time to wait for a response from a
supplicant (user) to send EAP Request/Identity packets.
supp_timeout <sec 1-65535> - Configures the time to wait for a response from
a supplicant (user) for all EAP packets, except for the Request/Identity
packets.
server_timeout <sec 1-65535> - Configure the length of time to wait for a
response from a Radius server.
max_req <value 1-10> − Configures the number of times to retry sending
packets to a supplicant (user).
reauth_period <sec 1-65535> − Configures the time interval between
successive re-authentications.
enable_reauth [enable|disable] − Determines whether or not the Switch will re-
authenticate. Enabled causes re-authentication of users at the time interval
specified in the Re-authentication Period field, above.
Restrictions Only administrator-level users can issue this command.
167