D-Link DES-3326S - Page 185

D-Link DES-3326S Layer 3 Switch CLI Reference
create access_profile
Purpose Used to create an access profile on the Switch and to define which parts of each
incoming frame’s header the Switch will examine. Masks can be entered that will
be combined with the values the Switch finds in the specified frame header fields.
Specific values for the rules are entered using the config access_profile
command, below.
Syntax
create access_profile
[ethernet {vlan | source_mac <macmask> | destination_mac <macmask> |
802.1p | ethernet_type} |
ip {vlan|source_ip_mask<netmask> | destination_ip_mask <netmask> | dscp |
[icmp {type | code} | igmp {type} | tcp {src_port_mask <hex 0x0-0xffff> |
flag_mask [ all | { urg | ack |psh |rst |syn| fin } ] } | dst_port_mask
<hex 0x0-0xffff>} | udp {src_port_mask <hex 0x0-0xfff> | dst_port_mask
<hex 0x0-0xffff>} | protocol_id { user_mask <hex 0x0-0xffffffff> } ] }
Description
The create access_profile command is used to create an access profile on the
Switch and to define which parts of each incoming frame’s header the Switch will
examine. Masks can be entered that will be combined with the values the Switch
finds in the specified frame header fields. Specific values for the rules are entered
using the config access_profile command, below.
Parameters
ethernet − Specifies that the Switch will examine the layer 2 part of each packet
header.
vlan − Specifies that the Switch will examine the VLAN part of each packet header.
source_mac <macmask> − Specifies a MAC address mask for the source MAC
address. This mask is entered in the following hexadecimal format:
destination_mac <macmask> − Specifies a MAC address mask for the destination
MAC address.
802.1p − Specifies that the Switch will examine the 802.1p priority value in the
frame’s header.
ethernet_type − Specifies that the Switch will examine the Ethernet type value in
each frame’s header.
ip − Specifies that the Switch will examine the IP address in each frame’s header.
vlan − Specifies a VLAN mask.
source_ip_mask <netmask> − Specifies an IP address mask for the source IP
address.
destination_ip_mask <netmask> − Specifies an IP address mask for the destination
IP address.
dscp − Specifies that the Switch will examine the DiffServ Code Point (DSCP) field
in each frame’s header.
icmp − Specifies that the Switch will examine the Internet Control Message Protocol
(ICMP) field in each frame’s header.
type − Specifies that the Switch will examine each frame’s ICMP Type field.
code − Specifies that the Switch will examine each frame’s ICMP Code field.
igmp − Specifies that the Switch will examine each frame’s Internet Group
Management Protocol (IGMP) field.
type − Specifies that the Switch will examine each frame’s IGMP Type field.
tcp − Specifies that the Switch will examine each frames Transport Control Protocol
(TCP) field.
src_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the source port.
dst_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the destination
port.
179