D-Link DES-3326S - Page 229

D-Link DES-3326S Layer 3 Switch CLI Reference
show iproute
Purpose Used to display the Switch’s current IP routing
table.
Syntax
show iproute {<network_address>}
{static|rip|ospf}
Description This command will display the Switch’s current
IP routing table.
Parameters
<network_address> − IP address and netmask
of the IP interface that is the destination of the
route. You can specify the address and mask
information using the traditional format (for
example, 10.1.2.3|255.0.0.0 or in CIDR format,
10.1.2.3|16).
static – use this to display static iproute entries.
rip – use this to display RIP iproute entries.
ospf – use this to display OSPF iproute entries.
Restrictions None.
Example Usage:
To display the contents of the IP routing table:
DES-3326S:4#show iproute
Command: show iproute
IP Address Netmask Gateway Interface Name Hops Protocol
--------------- --------------- --------------- --------------- ---- -----------
0.0.0.0 0.0.0.0 0.1.1.254 System 1 Default
10.0.0.0 255.0.0.0 10.48.74.122 System 1 Local
Total Entries: 2
DES-3326S:4#
223