D-Link DES-3326S - Page 231

D-Link DES-3326S Layer 3 Switch CLI Reference
create route redistribute dst ospf
Purpose Used to add route redistribution settings for the exchange of RIP routes to
OSPF routes on the Switch.
Syntax
create route redistribute dst ospf src [static|rip|local] {mettype
[1|2]|metric <value>}
Description This command will redistribute routing information between the OSPF and RIP
routing protocols to all routers on the network that are running OSPF or RIP.
Routing information entered into the Static Routing Table on the local DES-
3326S Switch is also redistributed.
Parameters
src [static|rip|local] − Allows for the selection of the protocol for the source
device.
mettype [1|2] − Allows for the selection of one of two methods of calculating
the metric value. Type-1 calculates (for RIP to OSPF) by adding the
destination’s interface cost to the metric entered in the Metric field. Type-2
uses the metric entered in the Metric field without change. this field applies
only when the destination field is OSPF.
metric <value> − Allows the entry of an OSPF interface cost. This is
analogous to a Hop Count in the RIP routing protocol.
Restrictions Only administrator-level users can issue this command.
Routing information source − RIP. the Static Route table, and the Local interface routing information. Routing
information will be redistributed to OSPF.
Route Source Metric Metric Type
RIP 0 to 16777214 mettype 1
mettype 2
Static 0 to 16777214 mettype 1
mettype 2
Local 0 to 16777214 mettype 1
mettype 2
Allowed Metric Type combinations are mettype 1 or mettype 2. The metric value 0 above will be redistributed
in OSPF as the metric 20.
Example Usage:
To add route redistribution settings:
DES-3326S:4#create route redistribute dst ospf src rip
Command: create route redistribute dst ospf src rip
Success.
DES-3326S:4#
225