D-Link DES-3326S - Page 251

D-Link DES-3326S Layer 3 Switch CLI Reference
enable dnsr
Purpose Used to enable DNS relay.
enable dnsr
This command is used, in combination with the
disable dnsr command below, to enable and
disable DNS Relay on the Switch.
Restrictions Only administrator-level users can issue this
command.
Syntax
Description
Parameters None.
Example Usage:
To enable status of DNS relay:
DES-3326S:4#enable dnsr
Command: enable dnsr
Success.
DES-3326S:4#
disable dnsr
Purpose Used to disable DNS relay on the Switch.
disable dnsr
Description This command is used, in combination with the
enable dnsr command above, to enable and
disable DNS Relay on the Switch.
Restrictions Only administrator-level users can issue this
command.
Syntax
Parameters None.
Example Usage:
To disable status of DNS relay.
DES-3326S:4#disable dnsr
Command: disable dnsr
Success.
DES-3326S:4#
245