D-Link DES-3326S - Page 297

D-Link DES-3326S Layer 3 Switch CLI Reference
delete ospf aggregation
Purpose Used to delete an OSPF area aggregation
configuration.
Syntax
delete ospf aggregation <area_id>
<network_address> lsdb_type [summary]
This command is used to delete an OSPF area
aggregation configuration.
Parameters
<area_id> − A 32-bit number in the form of an IP
address (xxx.xxx.xxx.xxx) that uniquely identifies
the OSPF area in the OSPF domain.
<network_address> − The 32-bit number in the
form of an IP address that uniquely identifies the
network that corresponds to the OSPF Area.
lsdb_type [summary] − Specifies the type of
address aggregation.
Restrictions Only administrator-level users can issue this
command.
Description
Usage Example
To configure the OSPF area aggregation settings:
DES-3326S:4#delete ospf aggregation 10.1.1.1 10.48.76.122|16
lsdb_type summary
Command: delete ospf aggregation 10.1.1.1 10.48.76..122|16
Lsdb_type summary
Success.
DES-3326S:4#
291