D-Link DES-3326S - Page 32

D-Link DES-3326S Layer 3 Switch CLI Reference
enable web
Purpose Used to enable the HTTP-based management
software on the Switch.
Syntax
enable web <tcp_port_number>
Description This command is used to enable the Web-
based management software on the Switch.
The user can specify the TCP port number the
Switch will use to listen for Telnet requests.
Parameters
<tcp_port_number> − The TCP port number.
TCP ports are numbered between 1 and 65535.
The “well-known” port for the Web-based
management software is 80.
Restrictions Only administrator-level users can issue this
command.
Example Usage:
To enable HTTP and configure port number:
DES-3326S:4#enable web 80
Command: enable web 80
Success.
DES-3326S:4#
26