D-Link DES-3326S - Page 36

D-Link DES-3326S Layer 3 Switch CLI Reference
reset
Purpose Used to reset the Switch to the factory default
settings.
Syntax
reset {config|system}
Description This command is used to restore the Switch’s
configuration to the default settings assigned from
the factory.
Parameters
config − If config is specified, all of the factory
default settings are restored on the Switch
including the IP address, user accounts, and the
Switch history log. The Switch will not reboot. New
user accounts information and IP settings will need
to be assigned.
system − If system is specified all of the factory
default settings are restored on the Switch. The
Switch will reboot. New user accounts information
and IP settings will need to be assigned.
If no parameter is specified, the Switch’s current IP
address, user accounts, and the Switch history log
are retained. All other parameters are restored to
their factory default settings. The Switch will not
reboot.
Restrictions Only administrator-level users can issue this
command.
Example Usage:
To restore all of the Switch’s parameters to their default values:
DES-3326S:4#reset config
Command: reset config
Success.
DES-3326S:4#
30