D-Link DES-3326S - Page 82

D-Link DES-3326S Layer 3 Switch CLI Reference
show packet ports
Purpose Used to display statistics about the packets sent
and received by the Switch.
Syntax
show packet ports <portlist>
Description This command is used to display statistics about
packets sent and received by ports specified in
the port list.
Parameters
<portlist> − specifies a range of ports to be
configured. The port list is specified by listing
the lowest Switch number and the beginning
port number on that Switch, separated by a
colon. Then highest Switch number, and the
highest port number of the range (also
separeted by a colon) are specified. The
beginning and end of the port list range are
seperated by a dash. For example, 1:3 would
specify Switch number 1, port 3. 2:4 specifies
Switch number 2, port 4. 1:3-2:4 specifies all of
the ports between Switch 1, port 3 and Switch 2,
port 4 − in numerical order.
Restrictions None.
Example Usage:
To display the packets analysis for port 14:
DES-3326S:4#show packet port 14
Command: show packet ports 14
Port number : 14
Frame Size Frame Counts Frames/sec Frame Type Total Total/sec
------------ ------------ ---------- ---------- --------- ---------
64 254290 52 RX Bytes 41286744 17290
65-127 38129 12 RX Frames 359507 86
128-255 51878 13
256-511 8058 3 TX Bytes 72755 0
512-1023 2046 0 TX Frames 335 0
1024-1518 5441 6
Unicast RX 2245 0
Multicast RX 57480 20
Broadcast RX 299782 66
76