D-Link DES-3326S Layer 3 Switch CLI Reference
Figure 1-3. Assigning the Switch an IP Address
In the above example, the Switch was assigned an IP address of 10.41.44.33 with a subnet mask of 255.0.0.0.
The system message Success indicates that the command was executed successfully. The Switch can now be
configured and managed via Telnet and the CLI or via the Web-based management agent using the above IP
address to connect to the Switch.
Note: Some nonalphanumeric characters may cause the Switch to reboot
if entered using the CLI interface. Be careful to use only alphanumeric
characters when entering commands.
3
To Next Page
Loading...
