D-Link DES-3326S Layer 3 Switch CLI Reference
config syslog host
Purpose Used to configure the syslog protocol to send system log data to a remote
host.
Syntax
config syslog host [all|<index 1-4>] {severity [informational|warning|all]|
facility[local0|local1|local2|local3|
local4|local5|local6|local7]|udp_port<int>| ipaddress <ipaddr>|
state[enable|disable]
Description
The config syslog host command is used to configure the syslog protocol to
send system log information to a remote host.
Parameters
all − Specifies that the command will be applied to all hosts.
<index 1-4> − Specifies that the command will be applied to an index of hosts.
There are four available indexes, numbered 1 through 4.
severity − Severity level indicator. These are described in the following:
Bold font indicates that the corresponding severity level is currently supported
on the Switch.
Numerical Severity
Code
0 Emergency: system is unusable
1 Alert: action must be taken immediately
2 Critical: critical conditions
3 Error: error conditions
4 Warning: warning conditions
5 Notice: normal but significant condition
6 Informational: informational messages
7 Debug: debug-level messages
88
To Next Page
Loading...
