D-Link DGS-1510 Series - Page 118

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
115
Switch# configure terminal
Switch(config)# interface vlan100
switch(config-if)# ip local-proxy-arp
switch(config-if)#
9-7 show arp
This command is used to display the Address Resolution Protocol (ARP) cache.
show arp [ARP-TYPE] [IP-ADDRESS [MASK]] [INTERFACE-ID] [HARDWARE-ADDRESS]
Parameters
ARP-TYPE
(Optional) Specifies the ARP type.
dynamic – Specifies to display only dynamic ARP entries.
static –Specifies to display only static ARP entries.
IP-ADDRESS [MASK]
(Optional) Specifies to display a specific entry or entries that belong
to a specific network.
INTERFACE-ID
(Optional) Specifies to display ARP entries that are associated with
a specific network.
HARDWARE-ADDRESS
(Optional) Specifies to display ARP entries whose hardware
address equal to this address.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Used to display a specific ARP entry, all ARP entries, dynamic entries, or static entries, or entries
associated with an IP interface.
Example
This example shows how to display the ARP cache.
Switch#show arp
S - Static Entry
IP Address Hardware Addr IP Interface Age (min)
----------------- ----------------- ------------- ---------------
S 10.31.7.19 08-00-09-00-18-34 vlan1 forever
10.90.90.90 00-01-02-03-04-00 vlan1 forever
Total Entries: 2
Switch#
9-8 show arp timeout
This command is used to display the aging time of Address Resolution Protocol (ARP) cache.