D-Link DGS-1510 Series - Page 119

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
116
show arp timeout [interface INTERFACE-ID]
Parameters
INTERFACE-ID
Specifies the interface ID.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display the configured ARP aging time.
Example
This example shows how to display the ARP aging time.
Switch#show arp timeout
Interface Timeout (minutes)
------------ -----------------
vlan1 60
------------ -----------------
Total Entries:1
Switch#
9-9 show ip interface
This command is used to display the IP interface information.
show ip interface [INTERFACE-ID] [brief]
Parameters
INTERFACE-ID
(Optional) Specifies to display information for the specified IP
interface.
brief
(Optional) Specifies to display a summary of the IP interface
information.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline