D-Link DGS-1510 Series - Page 148

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
145
Command Default Level
Level: 15.
Usage Guideline
Use this command to display the error statistics information of the SIO ports.
Example
This example shows how to display the error statistics information of the SIO ports.
Switch#debug show error ports unit 1 sio1
UNIT ID 1 SIO 1:
RX Frames TX Frames
--------- ---------
CRC Error 0 CRC Error 0
Undersize 0 STP Drop 0
Oversize 0 HOL Drop 0
Fragment 0 COS0 HOL Drop 0
Jabber 0 COS1 HOL Drop 0
Symbol Error 0 COS2 HOL Drop 0
Buffer Full Drop 0 COS3 HOL Drop 0
ACL Drop 0 COS4 HOL Drop 0
Multicast Drop 0 COS5 HOL Drop 0
VLAN Ingress Drop 0 COS6 HOL Drop 0
Invalid IPv6 Drop 0 COS7 HOL Drop 0
STP Drop 0
Storm and FDB Drop 0
MTU Drop 0
Switch#