D-Link DGS-1510 Series - Page 147

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
144
Switch#debug show packet ports unit 1 sio1
UNIT ID 1 SIO 1:
Frame Size/Type Frame Counts Frames/sec
--------------- ---------------------- -----------
rxHCTotalPkts 0 0
rxHCUnicastPkts 0 0
rxHCMulticastPkts 0 0
rxHCBroadcastPkts 0 0
rxHCOctets 0 0
rxHCPkt64Octets 0 0
rxHCPkt65to127Octets 0 0
rxHCPkt128to255Octets 0 0
rxHCPkt256to511Octets 0 0
rxHCPkt512to1023Octets 0 0
rxHCPkt1024to1518Octets 0 0
rxHCPkt1519to2047Octets 0 0
rxHCPkt2048to4095Octets 0 0
rxHCPkt4096to9216Octets 0 0
txHCTotalPkts 0 0
txHCUnicastPkts 0 0
txHCMulticastPkts 0 0
txHCBroadcastPkts 0 0
txHCOctets 0 0
txHCPkt64Octets 0 0
txHCPkt65to127Octets 0 0
txHCPkt128to255Octets 0 0
txHCPkt256to511Octets 0 0
txHCPkt512to1023Octets 0 0
txHCPkt1024to1518Octets 0 0
txHCPkt1519to2047Octets 0 0
txHCPkt2048to4095Octets 0 0
rxHCPkt4096to9216Octets 0 0
Switch#
14-13 debug show error ports unit
This command is used to display the error statistics information of the SIO ports.
debug show error ports unit [UNIT-ID] [ sio1 | sio2 ]
Parameters
UNIT-ID
Specifies the stacking unit ID.
sio1
Specifies to represent the lower stacking port.
sio2
Specifies to represent the higher stacking port.
Default
None.
Command Mode
Privileged EXEC Mode.