D-Link DGS-1510 Series - Page 146

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
143
14-12 debug show packet ports
This command is used to display the packet statistics information of the SIO ports.
debug show packet ports unit [UNIT-ID] [ sio1 | sio2 ]
Parameters
UNIT-ID
Specifies the stacking unit ID.
sio1
Specifies to represent the lower stacking port.
sio2
Specifies to represent the higher stacking port.
Default
None.
Command Mode
Privileged EXEC Mode.
Command Default Level
Level: 15.
Usage Guideline
Use this command to display the packet statistics information of the SIO ports.
Example
This example shows how to display the information of the SIO port.