D-Link DGS-1510 Series - Page 248

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
245
Switch#configure terminal
Switch(config)#ethernet ring g8032 ring1
Switch(config-erp)#instance 1
Switch(config-erp-instance)#rpl port0
Switch(config-erp-instance)#
28-15 show ethernet ring g8032
This command is used to display information of the ERP instances.
show ethernet ring g8032 {status | brief}
Parameters
status
Specifies to display the status of the ERP instances.
brief
Specifies to display the brief information of the ERP instances.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
This command is used to display information of the ERP instances.
Example
This example shows how to display the detailed information of the ERP instances.