D-Link DGS-1510 Series - Page 251

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
248
The activated ERP instance will be in non-operational state, if the specified APS channel does not
exist, or the specified ports are not the tagged member port of the APS channel VLAN.
Example
This example shows how to activate the instance 1.
Switch#configure terminal
Switch(config)#ethernet ring g8032 ring1
Switch(config-erp)#instance 1
Switch(config-erp-instance)#activate
Switch(config-erp-instance)#
28-17 timer
This command is used to configure timers for an ERP domain. Use the no form of this command to
revert to the default settings.
timer {guard MILLI-SECONDS | hold-off SECONDS | wtr MINUTES}
no timer {guard | hold-off | wtr}
Parameters
guard MILLI-SECONDS
(Optional) Specifies the guard timer in milliseconds. The value is
range from 10 to 2000.
hold-off SECONDS
(Optional) Specifies the hold-off timer in seconds. The value is
range from 0 to 10.
wtr MINUTES
(Optional) Specifies the WTR timer in minutes. The value is range
from 1 to 12.
Default
The default guard timer is 500 milliseconds.
The default hold-off timer is 0 second.
The default WTR timer is 5 minutes.
Command Mode
G.8032 Profile Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to configure timers for an ERP domain.
Example
This example shows how to configure guard timer to 700 for the profile campus.
Switch#configure terminal
Switch(config)#ethernet ring g8032 profile campus
Switch(config-g8032-ring-profile)#timer guard 700
Switch(config-g8032-ring-profile)#