D-Link DGS-1510 Series - Page 250

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
247
WTR timer
Time value for WTR timer of the profile
TC Propagation / No TC
Propagation
TC is propagated or not propagated in the profile
Revertive / Non-Revertive
Ring instances is operated in revertively or non revertively in the
profile.
Instance State
Current ring node status of ERP instance. Deactivated / Init / Idle /
Protection
Admin/Operational RPL
Current config/running config ring node role of ERPS instance.
(Owner /None)
Admin/Operational
Port0/port1
Current config/running config ring port role. (Interface_id /none)
Admin/Operational RPL Port
Current config/running RPL. (port0/port1 /none)
Ring port0/port1 state
State for ring ports of ERP instance. ( - / Forwarding / Blocked l)
Profile
The profile associated with the ring instances.
Inst ID
Instance identifier of ERP instance.
RingType
Indicates either major ring or sub ring.
Node Type
RPL Owner.
Status
Current status of ERP instance. It can be one of the following
values:
Deactivated: The ERP instance is deactivated.
Init: The instance is initializing.
Idle: The instance is in normal state. The RPL port is blocked.
Protection: The instance detects failure at some ring port. The
RPL port is restored to protect the port.
Port-State
Current ring ports state. (- / Forwarding / Blocked )
28-16 activate
This command is used to activate the specified ERP instance. Use the no form of this command to
deactivate the specified ERP instance.
activate
no activate
Parameters
None.
Default
By default, this option is no activate.
Command Mode
ERP Instance Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
This command is used to activate or deactivate the specified ERP instance. The ring ports, APS
channel, and ERP profile must be configured before activating the ERP instance.