D-Link DGS-1510 Series - Page 265

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
262
Level: 1.
Usage Guideline
This command is used to display the MAC address table’s aging time.
Example
This example shows how to display the MAC address table’s aging time.
Switch# show mac-address-table aging-time
Aging Time is 300 seconds
Switch#
30-10 show mac-address-table learning
This command is used to display the MAC-address learning state.
show mac-address-table learning [interface INTERFACE-ID [, | -]]
Parameters
INTERFACE-ID
(Optional) Specifies the interface to be display.
,
(Optional) Specifies a series of interfaces, or separate a range of
interfaces from a previous range. No spaces before and after the
comma.
-
(Optional) Specifies a range of interfaces. No spaces before and
after the hyphen.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If the interface is not specified, all existing interfaces will be displayed.
Example
This example shows how to display the MAC address learning status on all physical ports 1 to 10.