D-Link DGS-1510 Series - Page 266

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
263
Switch# show mac-address-table learning interface ethernet 1/0/1-10
Interface State
------------------------ --------
eth1/0/1 Enabled
eth1/0/2 Enabled
eth1/0/3 Enabled
eth1/0/4 Enabled
eth1/0/5 Enabled
eth1/0/6 Enabled
eth1/0/7 Enabled
eth1/0/8 Enabled
eth1/0/9 Enabled
eth1/0/10 Enabled
Switch#
30-11 show mac-address-table notification change
This command is used to display the MAC address notification configuration or history content.
show mac-address-table notification change [interface [INTERFACE-ID] | history]
Parameters
interface INTERFACE-ID
(Optional) Specifies the interface to display.
history
(Optional) Specifies to display the MAC address notification change
history.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If no option is specified, the global configuration will be displayed. Use the interface keyword to
display information about all interfaces. If the interface ID is included, the specified interface will be
displayed.
Example
This example shows how to display the MAC address notification change configuration on all
interfaces.