D-Link DGS-1510 Series - Page 269

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
266
no snmp-server enable traps mac-notification change
Parameters
None.
Default
By default, this option is disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use this command to enable the sending of SNMP MAC notification traps.
Example
This example shows how to enable the sending of SNMP MAC notification traps.
Switch# configure terminal
Switch(config)# snmp-server enable traps mac-notification change
Switch(config)#
30-14 snmp trap mac-notification change
This command is used to enable the MAC address change notification on a specific interface. Use the
no form of this command to revert to the default setting.
snmp trap mac-notification change {added | removed}
no snmp trap mac-notification change{added | removed}
Parameters
added
Specifies to enable the MAC change notification when a MAC
address is added on the interface.
removed
Specifies to enable the MAC change notification when a MAC
address is removed from the interface.
Default
By default, this option is disabled.
Command Mode
Interface Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Even when enabling the notification trap for a specific interface by using the snmp trap mac-
notification change command, the notification is sent to the notification history table only when the
mac-address-table notification change command was enabled.
Example
This example shows how to enable the MAC address added notification trap on interface eth1/0/2.