D-Link DGS-1510 Series - Page 268

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
265
Switch# show mac-address-table notification change history
History Index: 1
Operation:ADD Vlan: 1 MAC Address: 00-f8-d0-12-34-56 eth1/0/1
History Index: 2
Operation:DEL Vlan: 1 MAC Address: 00-f8-d0-00-00-01 eth1/0/1
History Index: 3
Operation:DEL Vlan: 1 MAC Address: 00-f8-d0-00-00-02 eth1/0/1
Switch#
30-12 show multicast filtering-mode
This command is used to display the filtering mode for handling multicast packets that are received on
an interface.
show multicast filtering-mode [interface VLAN-ID]
Parameters
interface VLAN-ID
(Optional) Specifies the VLAN to display.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
Example
This example shows how to display the multicast filtering mode configuration for all VLANs.
Switch#show multicast filtering-mode
Interface Layer 2 Multicast Filtering Mode
-------------------------------- --------------------------------
default forward-unregistered
Total Entries: 1
Switch#
30-13 snmp-server enable traps mac-notification change
This command is used to enable the sending of SNMP MAC notification traps. Use the no form of this
command to disable the sending of SNMP MAC notification traps.
snmp-server enable traps mac-notification change