D-Link DGS-1510 Series - Page 353

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
350
detail
(Optional) Specifies to display detailed channel group information.
neighbor
(Optional) Specifies to display neighbor information.
load-balance
(Optional) Specifies to display the load balance information.
sys-id
(Optional) Specifies to display the system identifier that is being
used by LACP.
Default
None.
Command Mode
EXEC Mode or Any Configuration Mode.
Command Default Level
Level: 1.
Usage Guideline
If a port-channel number is not specified, all port-channels will be displayed. If the channel, load-
balance and sys-id keywords are not specified with the show channel-group command, only
summary channel-group information will be displayed.
Example
This example shows how to display the detailed information of all port-channels.
Switch# show channel-group channel detail
Flag:
S - Port is requesting Slow LACPDUs F - Port is requesting fast LACPDU
A - Port is in active mode P - Port is in passive mode
LACP state:
bndl: Port is attached to an aggregator and bundled with other ports.
hot-sby: Port is in a hot-standby state.
indep: Port is in an independent state(not bundled but able to switch data
traffic)
down: Port is down
Channel Group 1
Member Ports: 2, Maxports = 12, Protocol: LACP
LACP Port Port
Port Flags State Priority Number
-------------------------------------------------
eth1/0/10 SA bndl 32768 10
eth1/0/11 SA bndl 32768 11
Channel Group 2
Member Ports: 2, Maxports = 12, Protocol: Static
LACP Port Port
Port Flags State Priority Number
--------------------------------------------------
eth3/0/8 N/A bndl N/A N/A
eth3/0/9 N/A down N/A N/A
Switch#
This example shows how to display the neighbor information for port-channel 3.