D-Link DGS-1510 Series - Page 368

DGS-1510 Series Gigabit Ethernet SmartPro Switch CLI Reference Guide
365
Switch# configure terminal
Switch(config)# lldp tx-interval 50
Switch(config)#
43-17 snmp-server enable traps lldp
This command is used to enable the LLDP and LLDP-MED trap state.
snmp-server enable traps lldp [med]
no snmp-server enable traps lldp [med]
Parameters
med
(Optional) Specifies to enable the LLDP-MED trap state.
Default
The LLDP and LLDP-MED trap states are disabled.
Command Mode
Global Configuration Mode.
Command Default Level
Level: 12.
Usage Guideline
Use the snmp-server enable traps lldp command to enable the sending of LLDP notifications.
Use the snmp-server enable traps lldp med command to enable the sending of LLDP-MED
notifications.
Example
This example shows how to enable the LLDP MED trap.
Switch# configure terminal
Switch(config)# snmp-server enable traps lldp med
Switch(config)#
43-18 lldp notification enable
This command is used to enable the sending of LLDP and LLDP-MED notifications for the interface.
Use the no form of this command to disable the sending.
lldp [med] notification enable
no lldp [med] notification enable
Parameters
med
(Optional) Specifies to enable the LLDP-MED notification state.
Default
The LLDP and LLDP-MED notification states are disabled.
Command Mode